IMPORTANT! When You Order Water4Gas E-books You Are Not Ordering The Devices Shown Below! |
|
Water4Gas.com offers a 300 pages easy guide on how to make and install the hydrogen system. Whit your order you will get free access to the readers-only marketplace where you can buy these discounted ready-to-install water for gas kits from more than 500 manufactures around the world.
Hydrogen Generator (Electrolyzer): A quart-sized highly durable jar contained unique coiled electrodes design (instead of plates) that use less battery electricity to produce more HHO. The hydrogen generator use the electrolysis process to converts water into hydrogen and oxygen. This is done by sending electricity from the car battery through the spirals suspended in the water. The tension caused by the 12 Volts electricity tears apart the H2O and produce hydrogen and oxygen gas as shown in the video below.
The generated HHO gas bubbles are sucked into the engine by the venturi suction (Gas Powered Suction)
.
Catalyst: Simple and safe Baking Soda, the catalyst is needed to conduct electricity in the distilled water to split H2o into HHO.
MAP Sensor Enhancer: When the HHO system improves the combustion quality, the oxygen sensor in your car will see much more oxygen and begin injecting more fuel. When this happens you will probably not see any mileage improvements due to the computer fighting against the Water4Gas device. The MAP Sensor Enhancer allows you to adjust the fuel injection and the amount of fuel going into the engine. The enhancer is very important for fine tuning your HHO system.
Vaporizer: Cools down the engine, enhances combustion and fuel economy by adding water vapor to the gasoline.
The PCV Enhacer: Also known as "PCV jar" is a important part of the Water4Gas hydrogen system. It cleans out harmful carbon dioxide and unused fuel from the engine. It keeps the spark plugs and the oil cleaner. It removes unwanted water and sludge out of the crankcase and recycles burnable gases.
Fuel Heater: The fuel heater uses the energy from the car radiator to pre-heat the fuel for better combustion efficiency and gas economy without any modifications to the radiator.
Two 3.5 feet vacuum hoses: One connect to the air filtert the other too the intake manifold.
Vacuum T-connector: Helps to feed the oxygen and hydrogen gas from the electrolyzer into the engine by connecting to the vacuum line.
Mechanical installation hardware: 8" cables for the Hydrogen Generator, bungee cords, 1/4" vinyl tubing, 11" cables for the Fuel Heater and flex tubing to protect wiring connection.
Each of the listed devices is an extremely powerful fuel saving tool and can easily be built from cheap hardware. With the help of the detailed illustrations in the e-books it takes only a few hours to put together the complete Water4Gas kit.
For more read water4gas review and latest water 4 gas information.
